If your compressor runs but pressure builds very slowly (or not at all), and you hear or feel air blowing back out of the inlet filter, the inlet valves are not sealing properly. On the upstroke, air should go to the next stage or receiver—but bad valves let it push back through the intake.
If there's no air blowing from the inlet but pressure still won't build, you likely have a leak somewhere in the system or worn internal components.
Industrial Reciprocating Troubleshooting
Not Building Pressure / Air Blowing Out Inlet – Industrial Reciprocating Air Compressor Troubleshooting
Compressor runs but pressure builds slowly or not at all—often air blows back out through the inlet filter.
Industrial systems
Field-tested diagnostics
Independent & unbiased
Safety Notice
Disconnect power and release all pressure before removing cylinder heads or valve covers. Compressed air can cause injury.
What this problem usually means
Check these first
5–10 minute checks before diving deeper
- Feel for air pulsing out of the inlet filter during operation
- Check for air leaks—listen for hissing at fittings, hoses, tank
- Inspect inlet air filter—is it clean and not collapsed?
- Check the head gasket area for air leaks
- Listen at the cylinder head for valve chatter or leakage sounds
- Is the tank drain valve fully closed?
- Check the safety valve—is it leaking or partially open?
- For multi-stage: check interstage connections and gaskets
Common root causes
Why this happens in industrial reciprocating compressors
Broken or worn inlet valves
Inlet valve plates are cracked, warped, or worn. Air blows back through inlet on compression stroke. Valve plates need replacement.
Broken or worn outlet valves
Outlet (discharge) valves not sealing properly. Compressed air leaks back during intake stroke instead of staying in the system.
Blown head gasket
Gasket failure between cylinder and head allows air to escape. Often accompanied by hissing sound and possibly overheating.
Clogged inlet filter
Severely restricted filter starves the compressor of air, drastically reducing output. Clean or replace the filter element.
Worn piston rings
Worn rings allow air to blow by the piston instead of being compressed. Usually accompanied by oil consumption and noise.
What NOT to do
Don't run the compressor continuously hoping it will eventually build pressure—if the valves are bad, you're just wearing out the motor and other components. Diagnose and fix the valve problem first.
Need deeper help with this issue?
If you've tried the basics and are still stuck, ask your question in the Q&A section. You'll get independent, practical guidance based on real-world experience.