wiring a 3 phase Air Compressor Pressure Switch Control Valve
Question
Hi,
Could you show me how to wire up a 3 phase condor air compressor pressure switch?
Regards, Michael.
1 Answer
Hello Michael,
Sure!
First, check out my page here: pressure switch models and options.
If you scroll down, you see a picture of the wiring. This is for a single phase compressor/pressure switch. For a three-page pressure switchs, it is basically the same, only you have 3 pairs of contacts.
The 3 wires from the motor are connected to the bottom 3 connections. The 3 incoming mains wires are connected to the top 3 connections.
Also see this information on the Condor website.
Hope this helps! Let me know if you need more information!
Good luck.
Cas.
Sure!
First, check out my page here: pressure switch models and options.
If you scroll down, you see a picture of the wiring. This is for a single phase compressor/pressure switch. For a three-page pressure switchs, it is basically the same, only you have 3 pairs of contacts.
The 3 wires from the motor are connected to the bottom 3 connections. The 3 incoming mains wires are connected to the top 3 connections.
Also see this information on the Condor website.
Hope this helps! Let me know if you need more information!
Good luck.
Cas.
Share Your Knowledge
Have experience with this issue? Help others by sharing your solution.