screw air compressor problem (electrical side)
Question
Getting problem of emergency stop in machine within few minute after start.
All cable connection are ok.
phase, fuses and connections are ok.
1 Answer
Hello,
Does it give an error message like 'high temperature' or 'emergency stop'?
If it is 'emergency stop', check the electrical connections on your emergency stop button, I have seen on several machines that because of vibrations the emergency stop gets activated.
If that's not it..
Usually, if the machine stops after a few minutes, it is because of too high temperature.
What is the element outlet temperature when the machine shuts down?
There is a temperature sensor that measures the element outlet temperature. Sometimes this sensor gives faulty readings or jumps up and down for no reason, or because of a loose connection.
Hope this helps! Good luck!
Cas
Share Your Knowledge
Have experience with this issue? Help others by sharing your solution.