controller power
i have controller power alarm. and i found damaged fuse for 110 and after changed start compressor for 1 minute then stopped and the fuse damage a gine and i get the same alarm controller power.
1 Answer
Hi,
Sounds like the controller board is drawing too much power - the most probable reason is a short somewhere.
Please check all electrical cables, sensors/pressure switch and loading solenoid - those are the most likely locations of a short.
If you can't find it this way - try to figure out if the fuse blows at a specific time, for example when the compressor unloads. If that is the case, the problem is probably with the cabling to the loading solenoid, or the solenoid itself.
Best,
Cas
Share Your Knowledge
Have experience with this issue? Help others by sharing your solution.