This topic contains 1 reply, has 2 voices, and was last updated by Cas Cas 3 weeks, 2 days ago.

This topic is posted in forum Rotary Screw Air Compressor Troubleshooting

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #6998 Reply

    Henry

    Quincy 325, record of change 14, circa 1977; 5HP, 20 CFM,60 gal tank:

    After changing the oil, there is no oil pressure. Oil level is OK, filter screen in base is clean. Spill valve seems OK. Pump is turning with crankshaft.
    Could it be the oil pump and how do I measure wear on the vanes?

    Any help will be appreciated.

    #7142 Reply
    Cas
    Cas
    Keymaster

    Hi Henry,

    I don’t have much experience with the Quincy units, but I did some ‘googling’ for you..

    Check this page, 3rd post from above: http://www.yesterdaystractors.com/cgi-bin/viewit.cgi?bd=toolt&th=127723

    Did you only change the oil? or did you also do some other stuff on the compressor?

    Maybe the pump was or is running in an ‘air bubble’ after changing the oil. I don’t know how it is exactly built up or anything, so I am just guessing here..

    anyway, hope this was helpful and good luck with your compressor! Let me know how it works out.

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Quincy 325 – no oil pressure
Your information: